Dongcheng DJG04-355B Çalıştırma Talimatları Kılavuzu - Sayfa 3
Kesme makineleri Dongcheng DJG04-355B için çevrimiçi göz atın veya pdf Çalıştırma Talimatları Kılavuzu indirin. Dongcheng DJG04-355B 9 sayfaları. Electric cut-off machine
Sayfayı Yazdır18. Do not use tool if switch does not turn it on or off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
19. Disconnect the plug from the power source and/or the battery pack from
the power tool before making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
20. Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to operate
the power tool. Power tools are dangerous in the hands of untrained users.
21. Maintain power tools. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the power tool's
operation. If damaged, have the power tool repaired before use. Many
accidents are caused by poorly maintained power tools.
22. Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
23. Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
Service
24. Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power tool
is maintained.
VOLTAGE WARNING:
Before connecting the machine to a power source (receptacle, outlet, etc.), be sure
the voltage supplied is the same as that specified on the nameplate of the machine.
A power source with voltage greater than that specified for the machine can result in
SERIOUS INJURY to the user, as well as damage to the machine. If in doubt, DO
NOT PLUG IN THE MACHINE. Using a power source with voltage less than
nameplate rating is harmful to the motor.
-3-
SPECIFICATIONS
Rated Power Input
No-Load Speed
Max. Cutting Angle
Max. Diameter for Cutting Discs
External Diameter
Wheel Size
Thickness
Internal Diameter
Pipe
Max. Cutting Capacity
Profiled Bar
Net Weight
※ Due to the continuing program of research and development, the specifications
herein are subject to change without prior notice.
ADDITIONAL SAFETY RULES
1. This cut-off machine should only be placed on the ground for operation, never try to
mount it on a table.
2. Wear hearing protection during extended periods of operation, also wear safety
glasses.
3. Use only wheels with maximum operating speed at least as high as "No-Load Speed"
indicated on the machine nameplate. Be sure to use only fiberglass-reinforced
wheels.
4. Check the wheel carefully for cracks or damage before operation. Replace cracked or
damaged wheel immediately. Run the tool (with guard) at no load for about a minute,
keeping tool away from others. If wheel is flawed, it will likely separate during this test.
5. Secure the wheel carefully.
2000 W
3800 r/min
45°
240 mm
355 mm
3 mm
25.4 mm
100 mm
95 mm×120 mm
17KG
-4-