Dongcheng DJG04-355B Çalıştırma Talimatları Kılavuzu - Sayfa 6

Kesme makineleri Dongcheng DJG04-355B için çevrimiçi göz atın veya pdf Çalıştırma Talimatları Kılavuzu indirin. Dongcheng DJG04-355B 9 sayfaları. Electric cut-off machine

Sayfayı Yazdır

machine cannot be used to bevel cutting.

To change the cutting angle, loosen the two hex bolts which secure the guide plate.

Move the guide plate to the desired angle (0° - 45°) and tighten the hex bolts

securely. (Fig. 8)

Securing Workpiece

CAUTION:

Always set the vise nut to right fully

when securing the workpiece. Failure to

do so may result in insufficient securing

of the workpiece. This could cause the

workpiece to be ejected or cause a

dangerous breakage of the wheel.

By setting the vise nut to left, the thread

shaft can be moved rapidly in and out.

To grip workpieces, set the vise nut to

left and push the thread shaft until the vise plate contacts the workpiece. Set the vise

nut to right and then turn the vise handle clockwise to securely retain the workpiece.

(Fig. 9)

 Spacer Blocks

When the cut-off wheel has worn down

considerably, use a spacer block of sturdy,

non-flammable

material

behind

workpiece. (Fig. 10)

You can more efficiently utilize the worn

wheel by using the midpoint on the

periphery of the wheel to cut the

workpiece.

 Cutting at an Angle

When cutting workpiece over 65mm wide at an angle, attach a straight piece of

the

-9-

wood (spacer) over 190mm long and 45mm wide to the guide plate. (Fig. 11)

Attach this spacer with screws through the holes in the guide plate.

If you use a spacer block which is slightly narrower than the workpiece. (Fig. 12) You

can also utilize the wheel economically.

 Cutting Long Workpieces

Long workpiece must be supported by blocks of

non-flammable material on either end so that it will

be level with the base top. (Fig. 13)

Switch Action

CAUTION:

Before plugging in the tool, always check to see that

the switch trigger actuates properly and returns to

the "OFF" position when released.

To start the machine, simply press the switch trigger.

Release the switch trigger to stop. For continuous

operation, pull the switch trigger and then push in

the lock button. To stop the machine from the locked

position, press the switch trigger fully and then release it. (Fig. 14)

-10-