Dongcheng DJG04-355B Çalıştırma Talimatları Kılavuzu - Sayfa 7

Kesme makineleri Dongcheng DJG04-355B için çevrimiçi göz atın veya pdf Çalıştırma Talimatları Kılavuzu indirin. Dongcheng DJG04-355B 9 sayfaları. Electric cut-off machine

Sayfayı Yazdır

Operation

CAUTION:

Proper handle pressure during cutting and maximum cutting efficiency can be

determined by the amount of sparks that is produced while cutting. Your pressure on

the handle should be adjusted to produce the maximum amount of sparks. Do not

force the cut by applying excessive pressure on the handle.

Hold the handle firmly. Switch on the machine and wait until the wheel attains full

speed before lowering gently into the cut. When the wheel contacts the workpiece,

gradually bear down on the handle to perform the cut. When the cut is completed,

switch off the machine and wait until the wheel has come to a complete stop before

returning the handle to the fully elevated position.

Cutting Capacity

The maximum cutting capacity of the machine depends on cutting angle and the

shape of the workpiece.

Shape of

Workpiece

Cutting

Angle

45°

100mm

95mm

90°

100mm

Carrying Machine

move

carry

the

machine

conveniently, depress the handle and

hang the chain into the hook. (Fig. 15)

95mm×105mm

100mm

95mm×120mm

125mm

-11-

MAINTENANCE AND INSPECTION

CAUTION:

Always be sure that the machine is switched off and unplugged before attempting to

perform inspection or maintenance.

After Use

Brush off accumulation of dust on the base. Accumulation of dust in the motor or on the

base may cause a malfunction of the machine.

Inspecting the Mounting Screws

Regularly inspect all mounting screws and ensure that they are properly tightened.

Should any of the screws be loose, retighten them immediately. Failure to do so could

result serious hazard.

Changing Cut-off Wheel

When the cut-off wheel has worn down considerably and results in reduced efficiency,

replace with a new one immediately.

Storing after Operation

Disconnect the machine after operation and store it out of reach of children.

Lubrication

To prolong the service life of this machine, lubricate the machine's active parts such as

those of shaft threads, vise plate and holder etc. every month.

Replacing Carbon Brushes

Remove and check the carbon brushes regularly. Replace when they wear down to the

limit mark (Fig. 16), in which time the motor will stop running automatically. Keep the

carbon brushes clean and free to slip in the holders. Both carbon brushes should be

-12-