Amerisun PowerSmart DB7651 Manuel

Araçlar Amerisun PowerSmart DB7651 için çevrimiçi göz atın veya pdf Manuel indirin. Amerisun PowerSmart DB7651 6 sayfaları. Auger belt tension adjustment

Sayfayı Yazdır

Auger Belt Tension Adjustment – DB7651

WARNING Entanglement Hazard -

performing any adjustment procedures, make sure the

engine is off and remove the spark plug wire from the

spark plug to ensure the engine cannot accidently start.

Never adjust belt tension with the engine running.

Note: During operation the augers turn at a slower

speed than the impeller, this is normal. The augers

are used to chop and cut the snow and direct it

into the impeller which is rotating at a high speed

to throw the snow up and out of the chute.

Over time, the auger cable tension may loosen and

or the auger belt may stretch. The auger cable will

require periodic adjustment to compensate for

these changes. Ideally, the cable should just be

barely tight when the auger handle is in the

released (disengaged) position.

Note: The proper operating tension for a typical V-

belt drive is - the lowest tension at which the belt

will not slip under a loaded condition.

DB7651 Controls and Cables

1. Drive Control Engagement Handle

2. Drive Speed Control Lever

3. Auger Control Engagement Handle

4. Chute Rotation Crank Handle

5. Drive Speed Cables

6. Auger Control Cable

7. Drive Control Cable

8. Drive Control Cable Adjustment Plate Slip Cover

Before

The auger cable is located on the left side (when

standing behind the snow blower) and is made up

of an upper and lower cable connected by an

adjustment plate. The adjustment plate is located

in-line with the cable below the control handle and

is covered by a black plastic slip cover. The

adjustment plate is used to adjust auger belt

tension.

Adjustment Plate

1. Upper Auger Cable (Always in upper center hole)

2. Adjustment Plate

3. Lower Auger Cable

4. Cable Pulley

5. Adjustment Plate Lower Cable Opening

6. Slip Cover

1. Stop the engine.

2. Disconnect the upper cable from the auger

control handle.

Upper Auger Cable Connection

Rev 1.0 3-23-13