Amerisun PowerSmart DB7651 Manuel - Sayfa 2

Araçlar Amerisun PowerSmart DB7651 için çevrimiçi göz atın veya pdf Manuel indirin. Amerisun PowerSmart DB7651 6 sayfaları. Auger belt tension adjustment

Sayfayı Yazdır

Rev 1.0 3-23-13

3. Slide up the slip cover to access the adjustment

plate.

Cable Adjustment Plate

4. Adjustment is made by changing the position of

the lower cable in the adjustment plate holes

(1 to 9). Only move the lower cable diagonally one

hole at a time from its original position.

Note: The upper cable end must be in the upper

single center hole of the adjustment plate. Do not

change the position of the upper cable.

4. Connect the upper cable to the control handle.

5. Start the engine and engage the auger to test

the operation of the auger.

Note: With the auger control handle at the full

released position, the cable should be barely tight.

Some slack in the cable may be required to ensure

the auger pulley tension pulley is not engaging the

belt. There should be no auger movement with the

auger handle released. If the auger is turning when

the auger handle is released, loosen the belt

tension by readjusting the cable as necessary. Do

not over tension the cable.