DoorHan Sectional-DIY-500 Kurulum ve Kullanım Kılavuzu - Sayfa 14
Kapı Açıcı DoorHan Sectional-DIY-500 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. DoorHan Sectional-DIY-500 20 sayfaları. Operator
Sayfayı Yazdır
I f you have lost this Manual, you may request for the duplicate copy to the following address: Kralovsky VRCH 2018,
Kadan, 43201, Czech Republic, or by e m ail: [email protected].
T he producer (DoorHan) does not supervise the installation of operators, or carry out their maintenance, thus DoorHan
cannot be held liable for safety of installation, operation and maintenance of the equipment.
8. TROUBLESHOOTING
Symptom
Operator does not run
Remote control does not run
Remote control actuation distance is too
small
Chain moves and door does not move
Door does not reach end positions or does
not work
Noise when operator runs
Chain makes noise and rubs against the
guide
The doors have suddenly stopped, "F"
indicator is on
14
Possible reason
1. No power
2. Fuse is broken
Remote control is not entered.
Remote control battery is discharged
Remote control battery is discharged
Carriage is disengaged and is not meshed with
chain support
Programming error
Chain is not properly lubricated
Chain has stretched
The doors ran into obstacle, or mechanics is blocked
TROUBLESHOOTING
Possible solution
1. Turn on the power
2. Replace the fuse
Re-entry the remote control
Replace the battery
Replace the battery
Engage the carriage. Connect it to chain support
Reprogram the door
Lubricate the chain
Tighten the chain using chain tension screw,
lubricate the gear wheel
Check the door mechanics, remove the obstacle