DoorHan SHAFT-30 Kurulum Kılavuzu - Sayfa 6

Kapı Açıcı DoorHan SHAFT-30 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DoorHan SHAFT-30 8 sayfaları. Ip65/60 ip65
Ayrıca DoorHan SHAFT-30 için: Manuel (12 sayfalar), Kurulum ve Kullanım Kılavuzu (12 sayfalar)

Sayfayı Yazdır

ELEcTrIcaL

inputs terminal board and power supply to accessories

connector for radio receiver (see note)

(not used)

motor terminal board

230 V ac power supply terminal board

limitswitch terminal board

lED

signalling key

tR1

transformer

5a  250 V(motor protection)

selfresetting (accessories protection )

•

to select the function logic, press the sW1 pushbutton the number of times equal to the number of the required logic, irrespective of the

current logic and the door status. the interval between the pulses must be less than 1 second.

•

the selected logic is then continuously displayed by the Dl1 lED, which flashes once a second at 3 sec intervals, equal to the number of

the required logic. to select the logics, press sW1 the number of times indicated in the table below:

7. Adjustment Limit switch

Rough adjusting (setting of the close limit)

•

Check that the operator has firmly

installed, close the door to fully closed

position and observe the rotating

direction of red limit cams during

closing. loose the screws of red limit

cams, then turn two cams in the same

direction until the limit switches click,

finally tighten the screws.

•

if the gap between the door and its

bottom position is larger than 20mm,

repeat this step until the door is less

than 20mm from the closed position.

in s ta l l at i o n ma n u a l s H aF t -3 0