Flying Tech G-Force250 Kullanım Kılavuzu - Sayfa 4

Dronlar Flying Tech G-Force250 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Flying Tech G-Force250 17 sayfaları. Fpv racing drone kit

4. Attach one motor to each arm using the

shorter screws that come in the power pack.

6. Stick the two foam pads onto the underside

of the PDB, noting their approximate position.

8. Remove the plugs leading from the twisted black/white wires on each ESC, then solder the

white wire to its local signal connection (S1-S4) and the black wire to the nearby ground

connection. Next shorten the red/black power wires and solder them to the ESC power

connections, note that the positive connection is labeled on the topside of the PDB.

9. Attach the short M3 spacers to the underside of the PDB (four for each motor arm), using the

M3x4mm button head screws and a washer for each along with a drop of thread lock.

5. Apply heat shrink to the three wires leading

back from each motor.

7. Stick the 4 ESCs onto the foam pads so that

their black wires point towards each other.