Astrolite WARRIOR 360 Kullanıcı Kılavuzu - Sayfa 11

Kontrolör Astrolite WARRIOR 360 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Astrolite WARRIOR 360 13 sayfaları.

selection. A flashing LED indicator on the number button indicates an existing chase.

Select the desired chases to add into the chase group. Once selected, the chase will start

running. Up to 48 steps can be added. Inactivate E/XY (LED indicator off), then adjust

running speed by the X/Speed function wheel.

Press ADD to add the selected chase into the chase group. It will automatically jump to the

next step and close the running chases.

Repeat Step 5-6 to add a new step.

Press Program to save the chase group and exit.

Note:

Anytime press Clear for a certain time, it will exit and cancel the programming.

X. Run a Chase Group

Step

Press Group

The LED indicator of the number button with an existing chase group will flash rapidly.

Select the desired number button to run the chase group. The LED indicator will slow down

the flash, which means that the chase group is now running.

Note:

Press Clear, it will close all the running chase groups.

XI. Function Wheel Assignment

The pan/tilt channel of the fixtures can be assigned to the function wheels on the controller for easy control.

Step

Press Program to enter programming mode

Select <=/SETX or =>/SETY

Select the desired fixture.

Push the slider of the pan/tilt channel of the fixture till the LED indicator is on.

Press <=/SETX or =>/SETY again to save and exit.

XII. The Use of Function Wheel

The channel that has been assigned to the function wheel can be controlled by the function wheel.

Step

Press E/XY, make sure the LED indicator is on.

Select the desired fixtures.

Control the fixture with the function wheels.

XIII. Setup of Slope Channels

Description