Air Hogs Jackal Kullanım Kılavuzu - Sayfa 2

Oyuncak Air Hogs Jackal için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Air Hogs Jackal 4 sayfaları.

BATTERY INSTALLATION – CONTROLLER/CHARGER

1. Open the battery door with a screwdriver (pic.1). 2. If used batteries are present, remove these batteries from the unit by pulling up on one end of each

battery. 3. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment (pic.2). 4. Replace battery door securely (pic.3).

5. Check your local laws and regulations for correct recycling and/or battery disposal.

1. Turn off both the helicopter and controller/charger.

2. Pull out the charging cord from the bottom of the

controller/charger (pic.1). 3. Carefully plug the charging

cord into the helicopter (pic.2). DO NOT FORCE THE

PLUG INTO THE PORT. When inserted properly, the

charging cord should fit easily into the charging port.

Incorrect insertion of the charging cord will damage the

helicopter and may create a hazard. 4. Turn the switch to

the ON/CHG position on the controller/charger (pic.3).

5. The controller/charger's charge LED will start to flash

(pic.4). 6. When the charge LED stops flashing and turns

off, charging is complete. 7. Turn controller/charger

switch to the OFF position before flying the helicopter.

Things to remember:

Before you recharge the battery or take the next flight,

wait 10-15 minutes to let the battery cool down.

1. INDOOR FLYER

Location – Fly in a wide-open room (ideally over 3 m wide x 5 m long x 2.5 m high), away from breakable items. Avoid flying near vents and/or fans, as these

may overpower the Jackal™ and make it difficult to control. NOTE: Always get permission to fly your Jackal™ indoors.

CAUTION: Never fly near your face. Keep rotor away from your fingers, hair, eyes and other body parts. Always lift off from a flat surface. Never hold the

flying heli in your hand when lifting off. DO NOT launch heli near people or animals. Stay away from obstacles and electrical hazards.

2. GETTING STARTED

1. Move the controller/charger's power/charge switch to ON (pic.1). 2. Set the ON/OFF switch of the helicopter to ON (pic.2). 3. Place the helicopter on the

ground with its' tail pointing toward you and the head facing away (pic.3). 4. Before take-off, the helicopter engine must be initiated to operate. To do this, pull the

throttle stick all the way down B, then slowly push it forward A. This will start the engine and the helicopter will be ready to fly (pic.4).

pic.1

3. TRIMMING YOUR HELICOPTER

STEP ONE

Gently push the throttle up to raise your helicopter about 1.5 metres above the ground.

If the helicopter spirals to the

right or keeps turning right,

push the Left/Right trim

wheel up until the helicopter

STEP TWO

flies straight.

If the helicopter spirals to the

left or keeps turning left, push

the Left/Right trim wheel

down until the helicopter

STEP THREE

flies straight.

HOW TO INSTALL YOUR BATTERIES

pic.1

HOW TO CHARGE YOUR JACKAL™

pic.1

HOW TO FLY YOUR JACKAL™

pic.2

Spirals right

Spirals left

pic.2

OFF

pic.3

Keeps turning right

Keeps turning left

pic.3

OFF

CHG

pic.4

pic.2

CHG

POWER

pic.4