COLE CL1350 Kullanım Kılavuzu - Sayfa 9

Plotter COLE CL1350 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. COLE CL1350 16 sayfaları. Cutting plotter

1 Place the machine on a smooth table, and keep enough room around it.

2 Keep machine away from strong electromagnetic disturbance or thick

dirt-powder.

3 Connect the machine to the computer by the serial or parallel cable, and

then turn the power on. If the carriage can automatically move right and

metal roller can rotate automatically, this means machine's automatic

reset.

4 If it fails to reset, press the "RESET" key.

5 The cutter holder should then rise 2mm or so. If you press "origin" key,

the holder will lower to its cutting depth; Release the key, the holder will

rise again. It shows the carriage and cutter holder can work properly.

6 If you want the machine to cut from appointed location, press the

"option" key, the yellow light will be on, press "←"or"→",the carriage

move to left or right; press"↓"or"↑",the media will move forward or behind.

Then press "ORIGIN" key, the machine will work at the point of blade's

location.

7 Press "TEST" key, the machine can start its own testing program and a

test-cut design will be automatically cut. This is a great way to adjust the

blade depth and ensure you are not over or under cutting the vinyl. You

want to just score the toplayer of the vinyl preventing any cutting on the

backing material. MAKE SURE the blade is deep enough to cut all

corners and edges of your vinyl test.

NOTE:

A. Turn off the power of computer and machine before connecting the

cable.

B. When you use the software, ensure to set controls such as: port,

commands set, baud rate and device, etc. to coordinate with the

cutting plotter. When you input data from computer to the machine,

the machine will work.

http://www.cncoletech.cn/

Cole Plotter User Manual

VII. Running Plotter in Test Mode