Asus 90MB10C0-M0EAY0 Manuel - Sayfa 12

Anakart Asus 90MB10C0-M0EAY0 için çevrimiçi göz atın veya pdf Manuel indirin. Asus 90MB10C0-M0EAY0 29 sayfaları.
Ayrıca Asus 90MB10C0-M0EAY0 için: Hızlı Başlangıç Kılavuzu (2 sayfalar)

Sayfayı Yazdır
Asus 90MB10C0-M0EAY0 Manuel
Before you install or remove any component, ensure that the ATX power supply is
switched off or the power cord is detached from the power supply. Failure to do so may
cause severe damage to the motherboard, peripherals, or components.
•
Actual lighting and color will vary with LED strip.
•
If your LED strip does not light up, check if the RGB LED extension cable and the
RGB LED strip is connected in the correct orientation, and the 12V connector is
aligned with the 12V header on the motherboard.
•
The LED strip will only light up when the system is operating.
•
The LED strips are purchased separately.
M.2_1/2 socket 3
These sockets allow you to install M.2 (NGFF) SSD
modules.
•
AMD Ryzen™ 2nd Generation/ Ryzen™ with
Radeon™ Vega Graphics/ Ryzen™ 1st Generation
Processors:
The M.2_1 socket supports PCIE 3.0 x4 and
SATA modes with M Key design and type
2242/2260/2280/22110 storage devices support
•
AMD Athlon™ with Radeon™ Vega Graphics
Processors:
The M.2_1 socket supports SATA mode with M Key
design and type 2242/2260/2280/22110 storage
devices support.
•
The M.2_2 socket supports PCIE 2.0 x4 with M Key
design and type 2242/2260/2280 storage devices
support.
AMD Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_1~6)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
System panel connector (20-5 pin F_PANEL)
This connector supports several chassis-mounted functions.
USB 3.1 Gen 1 (up to 5Gbps) connector (20-1 pin U31G1_12)
Connect a USB 3.1 Gen 1 module to this connector for additional USB 3.1
Gen 1 front or rear panel ports. This connector complies with USB 3.1 Gen 1
specifications and provides faster data transfer speeds of up to 5 Gbps, faster
charging time for USB-chargeable devices, optimized power efficiency, and
backward compatibility with USB 2.0.
USB 2.0 connectors (10-1 pin USB34,USB56)
Connect a USB module cable to any of these connectors, then install the module
to a slot opening at the back of the system chassis. These USB connectors comply
with USB 2.0 specifications and support up to 480Mbps connection speed.
1-3
M.2_1(SOCKET3)
22110
2280
2260
2242
M.2_2(SOCKET3)
2280 2260
2242
ASUS TUF B450-PRO GAMING