DOREMIDI MCV-10 Kullanım Kılavuzu - Sayfa 3
Medya Dönüştürücü DOREMIDI MCV-10 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DOREMIDI MCV-10 10 sayfaları. Midi to cv box
Sayfayı Yazdır3.2. GATE Parameters Table
Name
Output Voltage Range
(Vg)
Internal Resistance
(Ri)
Output Mode
Re-Trigger
Gate Delay
Gate Toggle
3.3. CV Parameters Table
Name
Output Voltage Range
(Vc)
Output impedance
(Re)
Output Mode
Output Priority
MIDI Note Range
3.4. AUX Parameters Table
Name
Output Voltage Range
(Va)
Output impedance
(Ra)
Output Mode
Vg = 0~15V (± 0.2V)
Note: Measured under no-load condition.
Ri = 1KΩ.
Note: The external load will affect the output voltage to a certain extent.
Support 0/5V, 0/15V, S-Trigger. Default 0/5V.
After enabling, When the Gate is open, if a new Note is generated, the MCV-10
will close the Gate, then open the Gate.
The time range is 0~5ms configurable. Disabled by default.
After enabling, When the CV outputs the voltage, the Gate can be turned on
after a delay, the time range is 0~1ms. Disabled by default.
After enabling, Swap the voltage state of the gate on and off. Disabled by
default.
V/Oct: Vc = 0~8.833V (± 10mV)
Hz/V: Vc = 0~14.3V (± 49mV)
1.2V/Oct: Vc = 0~10.6V (± 7mV)
Note: It is recommended to use it in the 0~8V region with the smallest error.
Re = 5.1KΩ@5V,
Note: That is, the output current is about 1mA. Below this load value, the
output voltage may be inaccurate.
Support V/Oct, Hz/V, 1.2V/Oct. Default V/Oct.
When multiple MIDI notes are generated, the MCV-10 determines which note
should output the voltage according to the priority:
New Note: Output the latest generated note every time, default.
High Note: When multiple notes are generated, only the voltage of the
highest note is output.
Low Note: When multiple notes are generated, only the voltage of the
lowest note is output.
In different output modes, the supported MIDI note ranges are different:
V/Oct: 21~127 (A0~G9)
Hz/V: 21~79 (A0~G5)
1.2V/Oct: 21~127 (A0~G9)
Va = 0~5V（±14mV）
Ra = 50KΩ@5V
Description: That is, the output current is about 1mA. Below this load value,
the output voltage may be inaccurate.
Support MIDI volume, pitch bend, after touch, MIDI CC.
Or receive a new note, output a pulse.
Description
Description
Description