Dorex DX1 PV/FV Kurulum Talimatları Kılavuzu - Sayfa 5

Kapı açma sistemi Dorex DX1 PV/FV için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Dorex DX1 PV/FV 12 sayfaları.

Sayfayı Yazdır

01. DRAW HORIZONTAL CENTERLINE (

Hinge

Side

to Finished

Mark horizontal centerline on inside face of door 39-5/8"

from finished floor as shown. (Continue horizontal center

line to outside face of door if trim is used)

03. ALIGN TOP & BOTTOM TEMPLATES ALONG

CENTERLINE, THEN MARK AND PREPARE DOOR.

C L

)

RHR shown

(LHR opposite)

C L

39-5/8"

Floor or

Threshold

1. Fold strike template and

place on door stop and

inside face of door, so

the vertical centerline on

template lines up with the

vertical centerline on door

stop and door.

2. Tape template on door stop

and the door face.

3. Mark centers and drill/tap

holes as indicated on the

template. See "DOOR

PREPARATION CHART"

on page 4 for drill/tap, and

cut-out information.

02. POSITION TEMPLATE AS SHOWN AND

MARK VERTICAL CENTERLINE

C L

Mark vertical center line X-X above and below horizontal

center line. (Mark vertical center line at lock side using same

backset dimension on outside face of door if trim is using).

CAUTION: Vertical center lines on both sides of the door

should be the same dimension from the edge

of the door. Use extra care if edge of door is

beveled. Be sure X-X vertical center line is

parallel to edge of door.

04. INSTALL TOP STRIKE AND SHIM.

Shim

DXAS106

Strike

Strike Screws

Shim

DXAS108

Strike

Strike Screws

Install a screw through each slot.

C L

DXAS215 Strike

Strike Screws