Canon LV-7565 Şartname - Sayfa 20
Projektör Canon LV-7565 için çevrimiçi göz atın veya pdf Şartname indirin. Canon LV-7565 47 sayfaları. Multimedia projectors
Ayrıca Canon LV-7565 için: Broşür ve Teknik Özellikler (6 sayfalar), Broşür (6 sayfalar), Teknik Özellikler (6 sayfalar)
Sayfayı Yazdır
Expand Serial Command Specification
8.5.3. CF_CLAMP Command
Command
"CF_CLAMP_%1" [CR]
"0000 ~ 0127" ----------- Directly set Clamp value
%1
"UP" ----------------------- Clamp setting value +1
"DN" ----------------------- Clamp setting value -1
Set Clamp. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
Details
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
Acceptable
Response
Unacceptable
8.5.4. CF_H-POS Command
Command
"CF_H-POS_%1" [CR]
"0000 ~ nnnn" --------- Directly set Horizontal Position
%1
"UP" --------------------- Horizontal Position setting value +1
"DN" --------------------- Horizontal Position setting value -1
Set Horizontal Position. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
Details
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
Acceptable
Response
Unacceptable
8.5.5. CF_V-POS Command
Command
"CF_V-POS_%1" [CR]
"0000 ~ nnnn" --------- Directly set Vertical Position
%1
"UP" --------------------- Vertical Position setting value +1
"DN" --------------------- Vertical Position setting value -1
Set Vertical Position. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
Details
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
Acceptable
Response
Unacceptable
the screen. To show up on the image, issue CF_SETPCADJ Command.
"000" [CR]
"101" [CR] ---- When Input is Video series
"nnnn" means maximum value. This result of current Total
Dots – Display Dots.
the screen. To show up on the image, issue CF_SETPCADJ Command.
"000" [CR]
"101" [CR] ---- When Input is Video series
"nnnn" means maximum value. This result of current Total
Line – Display Line.
the screen. To show up on the image, issue CF_SETPCADJ Command.
"000" [CR]
"101" [CR] ---- When Input is Video series
Page 19 of 46