Canon LV-7565 Специфікація - Сторінка 20
Переглянути онлайн або завантажити pdf Специфікація для Проектор Canon LV-7565. Canon LV-7565 47 сторінок. Multimedia projectors
Також для Canon LV-7565: Брошура та технічні характеристики (6 сторінок), Брошура (6 сторінок), Технічні характеристики (6 сторінок)
Друкувати сторінку
Expand Serial Command Specification
8.5.3. CF_CLAMP Command
Command
"CF_CLAMP_%1" [CR]
"0000 ~ 0127" ----------- Directly set Clamp value
%1
"UP" ----------------------- Clamp setting value +1
"DN" ----------------------- Clamp setting value -1
Set Clamp. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
Details
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
Acceptable
Response
Unacceptable
8.5.4. CF_H-POS Command
Command
"CF_H-POS_%1" [CR]
"0000 ~ nnnn" --------- Directly set Horizontal Position
%1
"UP" --------------------- Horizontal Position setting value +1
"DN" --------------------- Horizontal Position setting value -1
Set Horizontal Position. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
Details
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
Acceptable
Response
Unacceptable
8.5.5. CF_V-POS Command
Command
"CF_V-POS_%1" [CR]
"0000 ~ nnnn" --------- Directly set Vertical Position
%1
"UP" --------------------- Vertical Position setting value +1
"DN" --------------------- Vertical Position setting value -1
Set Vertical Position. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
Details
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
Acceptable
Response
Unacceptable
the screen. To show up on the image, issue CF_SETPCADJ Command.
"000" [CR]
"101" [CR] ---- When Input is Video series
"nnnn" means maximum value. This result of current Total
Dots – Display Dots.
the screen. To show up on the image, issue CF_SETPCADJ Command.
"000" [CR]
"101" [CR] ---- When Input is Video series
"nnnn" means maximum value. This result of current Total
Line – Display Line.
the screen. To show up on the image, issue CF_SETPCADJ Command.
"000" [CR]
"101" [CR] ---- When Input is Video series
Page 19 of 46