Dormakaba TP/TA EASY Safe Montaj Talimatları - Sayfa 13

İç Mekan Mobilyaları Dormakaba TP/TA EASY Safe için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. Dormakaba TP/TA EASY Safe 20 sayfaları.

Sayfayı Yazdır

dormakaba mounting instructions

4.7

Gluing the top door rail to an LSG

glass panel (optional)

The clamping of the top door rail is particularly

important because of the supporting function. If

vibrations are expected on the item, the glass panel

should also be glued in the top door rail area in

addition to the clamping.

The chambers in the gasket and the drill holes in the

door rail are already present. They are on the right

and left-hand on the face on the inside of the panel.

Requirements

• The top door rail is mounted on the glass panel.

• The glass panel is mounted.

Inject the adhesive through the fill hole.

Fig. 29

Injecting the adhesive

2. Stop the injection as soon as the adhesive

emerges from the outlet channel. The adhesive

chamber is completely full.

Outlet channel for

checking the fill level

Adhesive chamber

Fig. 30

Completely fill the adhesive chamber

3. Leave the adhesive to cure.

The curing time is 15 minutes at a room

temperature of approx. 23°C.

4. After 15 minutes, carefully remove excess adhesive

that has leaked out from the side.

TP/TA EASY Safe

Fill hole

WN 060028 45532

5. After a further 45 minutes, the door can be

carefully used.

Note

• The adhesive fully cures after 24 hours and

the unit can then be used normally.

• The 24-hour period starts 1 hour after

injecting the adhesive.

• Do not expose the door to any sudden

loads until the 24-hour period has expired.

4.8

Mounting the side panel

Note

The fixing materials are not included in

delivery. The fixing materials must be

suitable for the fabric of the building.

Fig. 31

Clearances for the side panel

If necessary, shorten the bottom rail to the

required length.

Mounting

2020-11