Daewoo electricals HEA1200 Kullanım Kılavuzu - Sayfa 5
Isıtıcı Daewoo electricals HEA1200 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Daewoo electricals HEA1200 9 sayfaları. 2000w flame effect stove heater
Sayfayı Yazdır
Insert the mains plug into the mains socket.
For the low heat setting, press the 1000w heat switch (3) and the fan
switch (2).
For the high heat setting, press both the 1000w heat switches (3 & 4) and
the fan switch (2).
Rotate the thermostat control (1) clockwise to increase the room
temperature and anticlockwise to decrease the room temperature as
desired.
The lights in the switches will illuminate and extinguish indicating that the
set temperature is being maintained.
NB
the fan switch (2) must be pressed in order for the heat function to
operate.
Hint on setting the correct temperature
Set the heater to the desired heat setting as above.
Rotate the Thermostat to the maximum position and allow the room to
warm up. Once the desired room temperature has been reached turn the
Thermostat anticlockwise until the heater just clicks off then turn it back up
clockwise very slightly. The Thermostat will now maintain the room
temperature, if necessary, further increasing or decreasing the thermostat
control may be required to 'fine tune' the ideal room temperature.
Using The Flame Effect
Press the on/off switch (2) to operate the flame effect, rotate the flame
brightness control (5) to vary the brightness of the effect. NB the flame
effect can be used separately from the fan and heating functions.
The flame effect is from a long life LED light source and there is no need to
change any lamps
Care and Use of your Stove Effect Heater
1. Always disconnect the stove effect heater from the mains power supply
and allow to cool before cleaning.
2. Clean outside of the heater with a clean damp cloth. Never clean with
harsh or abrasive cleaners.
3. Do not submerge any part of the stove effect heater in water or any other
liquids.