Daewoo electricals HEA1200 사용 설명서 - 페이지 5

{카테고리_이름} Daewoo electricals HEA1200에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daewoo electricals HEA1200 9 페이지. 2000w flame effect stove heater

 Insert the mains plug into the mains socket.

 For the low heat setting, press the 1000w heat switch (3) and the fan

switch (2).

 For the high heat setting, press both the 1000w heat switches (3 & 4) and

the fan switch (2).

 Rotate the thermostat control (1) clockwise to increase the room

temperature and anticlockwise to decrease the room temperature as

desired.

 The lights in the switches will illuminate and extinguish indicating that the

set temperature is being maintained.



the fan switch (2) must be pressed in order for the heat function to

operate.

Hint on setting the correct temperature

 Set the heater to the desired heat setting as above.

 Rotate the Thermostat to the maximum position and allow the room to

warm up. Once the desired room temperature has been reached turn the

Thermostat anticlockwise until the heater just clicks off then turn it back up

clockwise very slightly. The Thermostat will now maintain the room

temperature, if necessary, further increasing or decreasing the thermostat

control may be required to 'fine tune' the ideal room temperature.

Using The Flame Effect

 Press the on/off switch (2) to operate the flame effect, rotate the flame

brightness control (5) to vary the brightness of the effect. NB the flame

effect can be used separately from the fan and heating functions.

 The flame effect is from a long life LED light source and there is no need to

change any lamps

Care and Use of your Stove Effect Heater

1. Always disconnect the stove effect heater from the mains power supply

and allow to cool before cleaning.

2. Clean outside of the heater with a clean damp cloth. Never clean with

harsh or abrasive cleaners.

3. Do not submerge any part of the stove effect heater in water or any other

liquids.