Dot Origin VTAP50 Kurulum Kılavuzu - Sayfa 12
Kontrol Ünitesi Dot Origin VTAP50 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dot Origin VTAP50 16 sayfaları. Oem module
Sayfayı Yazdır
The connector J1 includes both USB and RS232 signals, as follows:
A typical RS232 cable has the following DB9 female connector pinout:
A PC or terminal RS232 connector is usually DTE (data terminating equipment), typically a
male DB9 with TXD on pin 3 and RXD on pin 2. The appropriate connecting cable is then a
DCE (data communications equipment) female DB9. TXD and RXD pins are swapped
between the DCE and DTE devices, so that the transmit pin on one connects to the receive
pin on the other.
The VTAP50 requires a 5V power supply, but not all RS232 devices have 5V on pin 9.
Either:
Disconnect the USB cable before making the serial connection, if power will be provided
l
by J1 (pins 1 and 3) and the serial cable/host.
Or retain a USB connection in addition to the serial connection, if power is not available
l
from your RS232 device.
Some serial cables have a separate DC 5.5/2.1mm barrel connector to supply power. In
these cables, typically, the centre pin is +5V and the outer barrel is GND.
VTAP50 OEM MODULE INSTALLATION GUIDE
Pin
Function
1
2
3
4
5
RS232 RXD (input)
6
Reserved (sense input)
7
RS232 TXD (output)
8
Reserved (sense GND)
Figure 3-5 Typical RS232 cable
Pin
Function
2
3
5
9
GND
USB D+
+5V supply
USB D-
TXD
RXD
GND
+5V supply
PAGE 7