Doug Fleenor Design E2E Yapılandırma Kılavuzu - Sayfa 6
Medya Dönüştürücü Doug Fleenor Design E2E için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. Doug Fleenor Design E2E 8 sayfaları. Ethernet to ethernet protocol converter
Sayfayı YazdırNetwork Topologies
The two network interfaces on the E2E can provide physical separation between the two data
streams. Systems wishing to minimize network usage may isolate the output stream to a
separate network. Below are two examples, the first isolates ArtNet data from a larger sACN
system, the second allows all traffic to reach all devices, and has a simple configuration. Please
note that the protocols used in the example can be changed to any of the supported protocols
on the supported protocols list located at the top of this manual.
Example 1 – Traffic Separation – sACN system with ArtNet dimmer:
In the below example ArtNet traffic is not seen by the sACN equipment, and the sACN light
board traffic gets converted to ArtNet based on the virtual port settings in the E2E. The Ethernet
Router may or may not use DHCP, and the E2E out and ArtNet dimmer use static IP. In cases
where the sACN side uses static addressing, or the light board provides a DHCP server, the
Ethernet router should be changed to an Ethernet switch in the example below.
Figure 3: Traffic Separation described in Example 1
Page 6 of 8