Baumer EAM ST Series Manuel - Sayfa 9
Medya Dönüştürücü Baumer EAM ST Series için çevrimiçi göz atın veya pdf Manuel indirin. Baumer EAM ST Series 28 sayfaları. Absolute encoder with canopen
Sayfayı YazdırElectronic gear function
4.4.5
The electronic gear function divides the position value by the gear factor. Therefore it transforms the position value into
the view of the application:
The gear factor (i) is defined as followed:
There are three objects that should be configured to use the electronic gear function.
0x2001-1 Enable
Set this object to the value "2" to enable the electronic gear function, while the value "1" disable it.
0x2001-2 Gear Value 1
This Object defines the numerator of the gear factor.
The range of this integer value is 1...32767.
0x2001-3 Gear Value 2
This Object defines the denominator of the gear factor.
The range of this integer value is 1...32767.
Figure 4: Example configuration of gear values
discrete gear with number of teeth
obj 2001h-2h
GearValue1
eg. 17 teeth
obj 2001h-3h
GearValue2
Encoder
eg. 8 teeth
Limitations
A useful gear ratio is greater than 0.125, while a gear ratio smaller than 1 may result in higher signal noise.
The maximum encoder turns in unpowered operation must be smaller than 2
The electronic gear function is useful for multiturn encoders. In case of singleturn encoders, the position value gets lost
after a power cycle.
Baumer_EAM580_360_CANopen_MA_EN_Rev0003.0000h_Index0004.docx
06.08.2018
=
=
Example
Application
1
2
Motor
6.25
gear ratio i =
1
29
(536'870'912) turns.
9/28
Example
gear box
Gear
i = 6.25
Application
obj 2001h-2h
GearValue1
eg. 625
625
=
100
obj 2001h-3h
GearValue2
eg. 100
Baumer Electric AG
Frauenfeld, Switzerland