Douglas Dynamics Fisher Minute Mount 2 XLS 50810 Kurulum Talimatları Kılavuzu - Sayfa 9

Otomobil Aksesuarları Douglas Dynamics Fisher Minute Mount 2 XLS 50810 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Douglas Dynamics Fisher Minute Mount 2 XLS 50810 17 sayfaları. Snowplow

Sayfayı Yazdır

HYDRAULIC HOSES

Do not use thread sealant/tape on hoses and ﬁ ttings.

This could damage the product.

1. Apply the caution label to each wing hose near the

wing ram ﬁ tting, as shown below.

CAUTION! Verify hoses from cylinder are

connected to correct manifold port or cylinder will

bend. The extend port is closest to the rod and the

retract port is closest to the base.

Wrap label around hose

and press ends together.

Assembling a hose to the incorrect wing ram

port can result in permanent damage to the

ram.

2. Attach all hoses to ﬁ ttings, routing hoses as

shown. Leave the hoses ﬁ nger tight at this time.

For blades built after March 2, 2010, remove and

discard the ﬁ tting caps from the blade extension

cylinder ﬁ ttings prior to attaching hoses. The build

date can be found in the ﬁ rst six digits of the serial

number, located in the upper right corner on the

back of the blade (YYMMDD: YY = 2-digit year,

MM = 2-digit month, DD = 2-digit day).

3/8" x 60" Hose

To DS Wing

Base (outside)

3/8" x 60" Hose

To DS Wing

Rod (inside)

3/8" x 45" Hose

To DS Angle Ram

3/8" x 57" Hose

To PS Wing

Rod (inside)

Lit. No. 50579, Rev. 02

CAUTION

1/4" x 18" Hose

To Lift Ram

3/8" x 42" Hose

To PS Angle Ram

3/8" x 57" Hose

To PS Wing

Base (outside)

3. Apply two protective hose wraps to each group

of hoses from the ﬁ tting side of the hydraulic unit

around and behind the jack leg and hydraulic

unit and over the headgear to the front. Apply

one hose wrap to each set of wing ram hoses

beginning near the wing ram ﬁ ttings.

4. Using a wrench to hold the hose end in position,

tighten all hose ﬁ ttings 1/8–1/4 turn past ﬁ nger

tight.

50600, 50810

April 15, 2010