Douglas Dynamics Fisher Minute Mount 2 XLS 50810 Інструкція з монтажу Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Автомобільні аксесуари Douglas Dynamics Fisher Minute Mount 2 XLS 50810. Douglas Dynamics Fisher Minute Mount 2 XLS 50810 17 сторінок. Snowplow
Друкувати сторінкуHYDRAULIC HOSES
Do not use thread sealant/tape on hoses and fi ttings.
This could damage the product.
1. Apply the caution label to each wing hose near the
wing ram fi tting, as shown below.
CAUTION! Verify hoses from cylinder are
connected to correct manifold port or cylinder will
bend. The extend port is closest to the rod and the
retract port is closest to the base.
Wrap label around hose
and press ends together.
Assembling a hose to the incorrect wing ram
port can result in permanent damage to the
ram.
2. Attach all hoses to fi ttings, routing hoses as
shown. Leave the hoses fi nger tight at this time.
For blades built after March 2, 2010, remove and
discard the fi tting caps from the blade extension
cylinder fi ttings prior to attaching hoses. The build
date can be found in the fi rst six digits of the serial
number, located in the upper right corner on the
back of the blade (YYMMDD: YY = 2-digit year,
MM = 2-digit month, DD = 2-digit day).
3/8" x 60" Hose
To DS Wing
Base (outside)
3/8" x 60" Hose
To DS Wing
Rod (inside)
3/8" x 45" Hose
To DS Angle Ram
3/8" x 57" Hose
To PS Wing
Rod (inside)
Lit. No. 50579, Rev. 02
CAUTION
CAUTION
1/4" x 18" Hose
To Lift Ram
3/8" x 42" Hose
To PS Angle Ram
3/8" x 57" Hose
To PS Wing
Base (outside)
3. Apply two protective hose wraps to each group
of hoses from the fi tting side of the hydraulic unit
around and behind the jack leg and hydraulic
unit and over the headgear to the front. Apply
one hose wrap to each set of wing ram hoses
beginning near the wing ram fi ttings.
4. Using a wrench to hold the hose end in position,
tighten all hose fi ttings 1/8–1/4 turn past fi nger
tight.
9
50600, 50810
April 15, 2010