Douglas Dynamics SnowEx V-Pro SP-2000 Kurulum Talimatları Kılavuzu - Sayfa 5

Serpme Douglas Dynamics SnowEx V-Pro SP-2000 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Douglas Dynamics SnowEx V-Pro SP-2000 17 sayfaları. Utv hopper spreader

Sayfayı Yazdır

SAFETY PRECAUTIONS

Improper installation and operation could cause

personal injury and/or equipment and property damage.

Read and understand labels and the Owner's Manual

before installing, operating, or making adjustments.

WARNING

• Driver to keep bystanders minimum of

25 feet away from operating spreader.

• Before working with the spreader, secure all

loose-ﬁ tting clothing and unrestrained hair.

• Before operating the spreader, verify that all

safety guards are in place.

• Before servicing the spreader, wait for

conveyor, auger, and spinner to stop.

• Do not climb into or ride on spreader.

WARNING

Overloading could result in an

accident or damage. Do not

exceed GVWR of UTV. See

Loading section to determine

maximum volumes of spreading material.

WARNING

Vehicles <10,000 lb GVWR: Obstructing the

visibility from the vehicle's rear camera could

result in serious injury or damage. An auxiliary

camera system shall be installed if the

vehicle's rear camera is removed or blocked.

CAUTION

If rear directional, CHMSL light, or brake

stoplights are obstructed by the spreader, the

lights shall be relocated, or auxiliary directional

or brake stoplights shall be installed.

Lit. No. 76451/76452/76453, Rev. 04

SAFETY

• Do not operate a spreader in need of

maintenance.

• Before operating the spreader, reassemble

any parts or hardware removed for cleaning

or adjusting.

• Before operating the spreader, remove

materials such as cleaning rags, brushes,

and hand tools from the spreader.

• Before operating the spreader, read the

engine owner's manual, if so equipped.

• While operating the spreader, use auxiliary

warning lights, except when prohibited by law.

• Tighten all fasteners according to the

torque chart. Refer to torque chart for the

recommended torque values.

Disconnect electric and/or hydraulic power

and tag out if required before servicing or

performing maintenance.

DO NOT leave unused material in

hopper. Material can freeze or solidify,

causing unit to not work properly.

Empty and clean after each use.

NOTE: Lubricate grease ﬁ ttings after each use.

Use a good quality multipurpose grease.

FUSES

The electrical system contains several automotive-style

fuses. If a problem should occur and fuse replacement

is necessary, the replacement fuse must be of the

same type and amperage rating as the original.

Installing a fuse with a higher rating can damage the

system and could start a ﬁ re.

CAUTION

February 24, 2020