Douglas Dynamics SnowEx V-Pro SP-2000 Kurulum Talimatları Kılavuzu - Sayfa 7

Serpme Douglas Dynamics SnowEx V-Pro SP-2000 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Douglas Dynamics SnowEx V-Pro SP-2000 17 sayfaları. Utv hopper spreader

Sayfayı Yazdır
These instructions cover vehicles that have been
recommended for carrying the hopper spreader. Please
see your local dealer for proper vehicle applications.
WARNING
Overloading could result in an accident or
damage. Do not exceed GVWR of UTV.
CAUTION
Read and adhere to manufacturer's
ice-control material package
labeling, including Safety Data
Sheet requirements.
CAUTION
Never use wet materials or materials with
foreign debris with any of these spreaders.
These units are designed to handle dry, clean,
free-fl owing material.

MATERIAL WEIGHTS

Material
(lb/ft
Salt
80
Sand
100
Material densities are approximate and are based on dry,
loose material. It is the responsibility of the operator to
know the weight of the material to be spread and the vehicle
carrying capacity.
Lit. No. 76451/76452/76453, Rev. 04
LOADING
Density
)
(lb/yd
)
(kg/m
3
3
2160
1282
2700
1602

DETERMINING VEHICLE PAYLOAD

1. Install the hopper spreader and optional
equipment according to the instructions.
2. Install or attach any other equipment that will be
on the vehicle while the hopper spreader will be in
use (step bumper, trailer hitch, snowplow, etc.). Fill
gas tanks.
3. Obtain the Gross Vehicle Weight Rating (GVWR)
from the UTV manufacturer.
4. With the occupants in the truck for normal hopper
spreader operation, weigh the vehicle to obtain
gross vehicle weight (GVW).
5. Subtract the GVW from the GVWR to determine
the available material payload.
6. Obtain the weight per cubic yard (lb/yd³) of the
desired material. Divide the weight into the
payload to determine the maximum volume of
material that can be carried.
7.
Fill the hopper with the calculated volume of material.
)
3
Reweigh the vehicle with occupants and verify that
the GVW is less than the vehicle's ratings.
8. Repeat Steps 6
7
7 for each type of material.
and
February 24, 2020