Douglas Dynamics DD 99494 Manuel - Sayfa 5

Işık Fikstürü Douglas Dynamics DD 99494 için çevrimiçi göz atın veya pdf Manuel indirin. Douglas Dynamics DD 99494 6 sayfaları. Strobe light kit stainless steel hopper spreaders

Sayfayı Yazdır

Electrical Connections

1. Plug the relay/fuse harness 10-pin connector into

the relay/fuse assembly.

2. Plug the strobe light harness connectors into the

matching connectors on the relay/fuse assembly

harness.

3. Remove the cover from the isolated stud block and

connect the relay/fuse assembly harness red wire

to the POSITIVE (+) terminal and the black wire

to the NEGATIVE (–) terminal. Replace the cover,

being careful not to pinch any wires. On spreader

Electric Spreader

Lit. No. 92945, Rev. 05

Gas Spreader

installations with multiple accessories, it may be

necessary to notch the sides of the isolated stud

block cover to accommodate all the wires.

4. Electric Spreaders: Connect the single-pin

terminal on the relay/fuse assembly harness

(yellow wire) to the white wire coming from port A

of the spreader module.

Gas/Hydraulic Spreaders: Connect the

single-pin terminal on the relay/fuse assembly

harness (yellow wire) to the white wire coming

from the previously installed hopper accessory

cable assembly.

Isolated

Stud Block

Hydraulic Spreader

Electric Spreader (0.35 & 0.7 yd

99494

)

August 1, 2020