Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM Kurulum Talimatları - Sayfa 2

Tekne Ekipmanları Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM 4 sayfaları.

Sayfayı Yazdır
STEP 2
Using a tape measure, locate & mark where each mounting button will be installed for the particular boat model you own (see Fig. 1 for
Gunnel mount). All measurements are to the center on the buttons and studs.
(FIG. 1)
SIDE DECK BOATS
Boat
Dimension
model
from aft cap
Trophy
2"
T-Pro
2"
Edge
2"
GUNNEL BOATS
Boat
Dimension
model
from aft cap
Competitor
2"
175 / 185 / 205
Competitor 165
2"
Voyageur
2"
Classic
2"
STEP 3
Inspect the area underneath the gunnel to be sure obstructions or wiring is out of the way. Drill a pilot hole at the proper mounting button
location with a 3/ 1 6" drill bit. Install the aft mounting button using the mounting button screw in the area described above by inserting the
screw through the center of the mounting button and secure with a #3 Philips bit (see photos above). Repeat this step for the other aft
corner mounting location.
STEP 4
Install a mounting button onto the bow plate. Using a tape measure locate the center on the aft edge of the bow plate. Measure 1 ½" from
the aft edge of the bow plate for the mounting button location. You have to install the mounting button 1 ½" to the right of bow navigation
light socket. Inspect the area underneath the bow plate to be sure obstructions or wiring is out of the way. Drill a pilot hole at the proper bow
mounting button location with a 3/ 1 6" drill bit. Insert the screw through the center of the mounting button and secure with #3 Philips bit (see
Fig. 9).
STEP 5 - INSTALLING BOW PLATE SNAPS
Deploy cover as detailed in steps 7–12. Be sure the cover is centered and taut. Mount 5/8" bow snap studs 1 ½" forward of aft edge of bow
plate and align with female snaps on the cover. Repeat for remaining female bow snap locations. Fasten the bow snaps of the cover to the
studs just installed. Note, you may need to loosen the side ratchets and remove aft corners to snap bow snaps.
STEP 6 - INSTALLING MOTOR WELL SKIRT SNAPS
Deploy cover as detailed in steps 7–13. Mount aft motor well snap studs. For studs into metal, use a 7/64" drill bit for pilot holes and use 3/8"
snap studs. For studs into carpet use 5/8" snap studs. The drop skirt may vary by boat model. Start with a snap closest to the center of the
boat and work out alternating from port to starboard. Pull down slightly on the skirt so the bottom edge is straight across the motor well. Aft
snap studs should align with female snaps on the cover. Then install remaining snaps so the skirt's bottom edge is straight across the motor
well (see Fig. 11).
NOTE
Ensure cover fits properly and tight, indicating all mounting locations line up with cover. At this point, cover can be removed
and packed away.
2
Dimension from inboard
edge of inboard trim
1"
1"
1"
Dimension from outboard side
of gunnel (second grove)
1"
¾"
¾"
¾"
Aft Button Gunnel A
Aft Button Side Deck A
Aft Button Gunnel B
Aft Button Side Deck B
142674-00 | 06/17