Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM Instrukcje instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Sprzęt żeglarski Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM. Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM 4 stron.

Drukuj stronę

STEP 2

Using a tape measure, locate & mark where each mounting button will be installed for the particular boat model you own (see Fig. 1 for

Gunnel mount). All measurements are to the center on the buttons and studs.

(FIG. 1)

SIDE DECK BOATS

Boat

Dimension

model

from aft cap

Trophy

T-Pro

Edge

GUNNEL BOATS

Boat

Dimension

model

from aft cap

Competitor

175 / 185 / 205

Competitor 165

Voyageur

Classic

STEP 3

Inspect the area underneath the gunnel to be sure obstructions or wiring is out of the way. Drill a pilot hole at the proper mounting button

location with a 3/ 1 6" drill bit. Install the aft mounting button using the mounting button screw in the area described above by inserting the

screw through the center of the mounting button and secure with a #3 Philips bit (see photos above). Repeat this step for the other aft

corner mounting location.

STEP 4

Install a mounting button onto the bow plate. Using a tape measure locate the center on the aft edge of the bow plate. Measure 1 ½" from

the aft edge of the bow plate for the mounting button location. You have to install the mounting button 1 ½" to the right of bow navigation

light socket. Inspect the area underneath the bow plate to be sure obstructions or wiring is out of the way. Drill a pilot hole at the proper bow

mounting button location with a 3/ 1 6" drill bit. Insert the screw through the center of the mounting button and secure with #3 Philips bit (see

Fig. 9).

STEP 5 - INSTALLING BOW PLATE SNAPS

Deploy cover as detailed in steps 7–12. Be sure the cover is centered and taut. Mount 5/8" bow snap studs 1 ½" forward of aft edge of bow

plate and align with female snaps on the cover. Repeat for remaining female bow snap locations. Fasten the bow snaps of the cover to the

studs just installed. Note, you may need to loosen the side ratchets and remove aft corners to snap bow snaps.

STEP 6 - INSTALLING MOTOR WELL SKIRT SNAPS

Deploy cover as detailed in steps 7–13. Mount aft motor well snap studs. For studs into metal, use a 7/64" drill bit for pilot holes and use 3/8"

snap studs. For studs into carpet use 5/8" snap studs. The drop skirt may vary by boat model. Start with a snap closest to the center of the

boat and work out alternating from port to starboard. Pull down slightly on the skirt so the bottom edge is straight across the motor well. Aft

snap studs should align with female snaps on the cover. Then install remaining snaps so the skirt's bottom edge is straight across the motor

well (see Fig. 11).

NOTE

Ensure cover fits properly and tight, indicating all mounting locations line up with cover. At this point, cover can be removed

and packed away.

Dimension from inboard

edge of inboard trim

Dimension from outboard side

of gunnel (second grove)

¾"

Aft Button Gunnel A

Aft Button Side Deck A

Aft Button Gunnel B

Aft Button Side Deck B

142674-00 | 06/17