Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM Instrukcje instalacji
Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Sprzęt żeglarski Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM. Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM 4 stron.
Drukuj stronęALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM
INSTALLATION INSTRUCTIONS — CARE & USE GUIDELINES
Please carefully read the entire instructions before proceeding. To emphasize special information you may see these symbols and words:
WARNING
Indicates potential hazard
that could result in death
or injury
Pay special attention to these messages. It is very important to us that you read and understand these installation instructions. If while
reading these instructions you are unsure about installing the cover, please feel free to contact the dealer where you purchased your boat.
Improper installation as a result of not following these instructions may result in damage to the canvas that is not covered by the warranty.
INSTALLATION:
NOTE: TOOLS REQUIRED
If you need to install mounting hardware you will need a tape measure, a grease pencil/crayon/pen, #2 and #3 Philips
screwdriver bit, 3/ 1 6" drill bit, 1/8" drill bit, 7/ 6 4" drill bit, center punch, power drill, hammer, safety glasses
WARNING
Be sure to use all required safety equipment when using tools and installing hardware
CONGRATULATIONS, YOU HAVE PURCHASED THE LATEST INNOVATION IN BOAT COVERS!
This cover uses a new way to fasten to your boat. It has a support system that uses no poles. You don't need to crawl under the cover to
prop up the poles. Instead a unique rope-ratchet & strap support system is securely sewn into the underside of the cover. Once the cover is
installed on the boat you simply pull on the rope ratchet to create tension with the straps underneath. The straps rise up slightly creating the
tented effect so that water or rain will run off the cover.
Your boat dealer or the factory may have pre-installed the mounting hardware for the cover — if yes, skip to STEP 7 for cover deployment
instructions. If this has not been done please follow the installation instructions. Locate the mounting hardware and make sure you have all
of the parts indicated.
STEP 1: INSTALLING SPECIAL HARDWARE FOR YOUR COVER
CAUTION
Make sure there are no wires, fuel lines,
or hoses behind the areas you are drilling
MOUNTING HARDWARE
Mounting Buttons
Quantity: 3
1
CAUTION
Indicates potential
hazard that could
result in boat damage
If the female snaps are not installed into the cover you must install them
using a snap setting tool. Snaps must be installed about ½" from the edge of
cover through the black webbing. Do not install snaps through the cover without
going through webbing. Location of snaps will be marked with white lines on back
side of cover.
Mounting Button Screws
Quantity: 3
NOTE
Indicates special information
to make maintenance easier
or instructions clearer
Snap Studs
3/8" when mounting into metal
5/8" when mounting on carpet
Quantity: 8-14 (depending on model)
142674-00 | 06/17