Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM Instrukcje instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Sprzęt żeglarski Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM. Dowco ALUMACRAFT BOAT COVERS WITH COVER-LIFT SYSTEM 4 stron.

Drukuj stronę

COVER DEPLOYMENT

STEP 7: PUTTING THE COVER ON THE BOAT

Unfold the cover and locate the sewn-in white ID tag at the front of the cover. Carefully review and become familiar with the strap and the

rope ratchet system. Carefully lay the cover over the boat from front to back going over the windshield. Carefully thread cover bow opening

over and around mounted trolling motor (if applicable) and secure cover over bow plate

(see Fig. 7).

STEP 8

Locate the strap ends at the back corners of the cover. The black key-hole shaped part slides over the

installed mounting buttons. (see Fig. 8). Secure each side now.

STEP 9

At the front of the cover is another key-hole shaped part that should slide over the installed bow plate

mounting button (see Fig. 9). Fasten bow cover snaps to bow plate snap studs.

STEP 10

Pull the cover to the back of the boat so it reaches and covers the corners of the gunnel. Secure the

aft corners of the cover to the boat. The corners may vary by model. Pull cover over and below gunnel

tight around the perimeter of the boat.

STEP 11

Connect corner hooks to U-bolts on transom face (see Fig. 10). Locate ratchet pockets on each side of the cover at the aft. Zip open the

pocket. Tighten strap until side ratchets are to the rear of center in each pockets. Locate end of the rope that is threaded through the

ratchet and pull it until all slack is gone. Repeat on the other side.

STEP 12

Tighten side ratchets by activating ratchet lever so cover cinches over the gunnel evenly. Be sure to keep both port and starboard ratchets

centered in the ratchet pockets. Re-inspect cover to ensure ratchet system is tight and under gunnel. If the cover is tight against the boat

you should not be able to get your fingers under the hem. If loose, continue to tighten the ratchets.

STEP 13

The Cover-Lift support system can be activated on either side of

the cover. At the back of the cover, open the zipper and locate the

rope attached to the ratchet (see Fig. 14 & 15). Tighten rope by

pulling tight (see Fig. 16). The fully tightened rope ratchet creates

tension on the straps going to the bow of the boat and slightly lifts

the cover providing support and creating slope for rain/water to

run off the cover.

STEP 14

Secure snaps on the drop skirt at the motor well or splash pan of

the transom. (see Fig. 11)

STEP 15

Trailering straps must be properly installed when trailering your

boat. There are a total of 3 straps (1 port midship, 1 starboard

midship, 1 bow). Thread the web strap through the tri-glide,

around the trailer, then through the side release buckle, as shown

in Fig. 20. Add a twist to the midship straps. Pull all 3 straps tight

prior to trailering.

(FIG. 9)

(FIG. 10)

(FIG. 7)

(FIG. 8)

(FIG. 11)

142674-00 | 06/17