Caraudio-Systems c.LOGiC lite C1-MFD3 Manuel - Sayfa 8
Kayıt Ekipmanları Caraudio-Systems c.LOGiC lite C1-MFD3 için çevrimiçi göz atın veya pdf Manuel indirin. Caraudio-Systems c.LOGiC lite C1-MFD3 12 sayfaları. For navigation systems volkswagen mfd3/rns510, rns810 skoda columbus seat trinax
Sayfayı Yazdır3.3.1. AV-source
The c.LOGiC interface has the possibility to connect and remotely control by navigation
buttons one pre-programmed device. The device list in the device control table (Appendix A)
shows the pre-programmed remote channels and the related IR-remote cables STA-xxx
which must be ordered separately for the control of the device.
Using the respective STA-xxx IR-control cable, interconnect the blue female 3pin AMP
connector of harness C1C-VW03 and the IR-port of the AV-source.
Using an RCA-cable, interconnect the female RCA-port Video In of the Interface-box
C1C-M03 with the AV-output of the AV-source.
The pink ACC-output wire (+12V max 1A) of the 4pin cable can be connected to the
ACC-input wires of the connected device to switch it on. It carries +12V when the
head-unit is running.
3.3.2. Installing AV-source's IR-sensor additionally
Additionally to the control via OEM navigation, it is possible to install the original IR-sensor
of a connected device. By using the respective Y-adapter (e.g. STA-Y35MM or STA-RJ12) for
the IR-Port of the connected device, the controls of navigation AND device's IR-sensor can be
connected and used simultaneously. Installation of the IR-sensor is recommended as the
controls via navigation are limited, and not all functions may be covered.
Version 24.01.2012
C1-MFD3