Ampro NEO 300 BEAM Kullanıcı Kılavuzu - Sayfa 8

DJ Ekipmanları Ampro NEO 300 BEAM için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Ampro NEO 300 BEAM 18 sayfaları. Moving head

3 DMX CONTROL CONNECTION

Connection between controller and projector and between one projector and another must be made with a

twin-screened cable, with each wire having at least a 0.5mm in diameter.

Connection to and from the projector is via cannon 5 pin (which are included with the projector) or 5 pin XLR

plugs and sockets. The XLR's are connected as shown in the figure above.

Note: care should be taken to ensure that none of the pins touch the metallic body of the plug or each other.

XLR plugs and sockets mustn't be connected in any way other than mentioned in the above figure.

The XR330BWS accepts digital control signals in protocol DMX512 (1990).

Connect the controller's DMX output to the first fixture's DMX input, and connect the first fixture's DMX output

to the second fixture's DMX input and connect the rest fixtures in the same way.

Eventually connect the last fixture's DMX output to a DMX terminator as shown in the figure below.

4 DMX TERMINATOR

In the Controller mode, at the last fixture in the chain, the DMX output has to be connected with a DMX

terminator. This prevents electrical noise from disturbing and corrupting the DMX control signals.

The DMX terminator is simply an XLR connector with a 120 (ohm) resistor connected across pins 2 and 3, which

is then plugged into the output socket on the last projector in the chain. The connections are illustrated below.

CONSOLE

DMX TERMINATOR

OUTPUT

INPUT

OUTPUT

INPUT

OUTPUT

INPUT

P. 8

English Version | NEO 300 BEAM