Draper Nocturne+E Talimatlar Kurulum ve Çalıştırma - Sayfa 4

Projeksiyon Perdesi Draper Nocturne+E için çevrimiçi göz atın veya pdf Talimatlar Kurulum ve Çalıştırma indirin. Draper Nocturne+E 8 sayfaları.

Sayfayı Yazdır
Nocturne+ E

Section 4 - Installing Cable Guides

1.
Loosly fasten the
nut on the cable
on the bottom
bracket
(wall
mount option
.
shown)
7.
Crimp the barrels
approximately
1/ 8 "
pencil mark.
PLEASE NOTE: Use an appropriately
sized crimping tool, such as the one
shown below
(supplied by installer)
7
(20cm)
CAUTION: Headbox
shown removed from
image for demonstration
purposes ONLY.
Do not remove endcap or
disassemble unit.
3.
Pull cable through the
hole in the endcap
flange until taut.
4.
2.
Pull cable up through
hem bar eyelet.
above
(3mm)
.
Mark cable at
the bottom of
the endcap
flange.
8.
Cut cable
approximately
1"
above
(25mm)
crimped barrels.
9.
Pull cable
down, until
crimped
barrels are
resting on
the flange.
5.
Undo the nut and
pull the cable down,
until the mark aligns
with the bottom
of the endcap
(deck mount
.
option shown)
6.
Strip cable
to that spot.
10.
Reassemble cable
and nut on the
bottom bracket and
tighten
option shown)
page 4 of 8
(wall mount
.