Draper Targa Talimatlar Kılavuzu - Sayfa 7

Projeksiyon Perdesi Draper Targa için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper Targa 8 sayfaları. Electrically operated projection screen with motor-in-roller
Ayrıca Draper Targa için: Kurulum ve Kullanım Talimatları (4 sayfalar), Kurulum ve Kullanım Talimatları (2 sayfalar), Kurulum ve Kullanım Talimatları (2 sayfalar), Kurulum ve Kullanım Talimatları (2 sayfalar), Kurulum ve Kullanım Talimatları (4 sayfalar), Kurulum ve Kullanım Talimatları (2 sayfalar), Kurulum ve Kullanım Talimatları (3 sayfalar), Kurulum ve Kullanım Talimatları (4 sayfalar), Kurulum ve Kullanım Talimatları (2 sayfalar), Kurulum ve Kullanım Talimatları (2 sayfalar)

Sayfayı Yazdır
Draper Targa Talimatlar Kılavuzu
Targa

Section 7 - Wiring Diagrams: Motor with Internal Low-Voltage Controller

110-120V MOTOR AND QUIET MOTOR
110-120V Motor
(Motor with internal low-voltage controller - ILT)
(Internal Low-Voltage Controller for ILT motor)
Single Station Control
Internal Screen Wiring
White (Neutral)
Black
Green/Yellow (Ground)
Data Cable
Dashed wiring
by electrician.
RJ-9
connector
Wall Switch,
RF or IR
Receiver,
or integrated
control system.
To 110-120V Line
Motor with Internal Low-Voltage Controller: Switch-to-Motor
CAUTION: Although both Dry Contact and Data Cable connections are shown, only one connection type per motor should be used.
Please Note:
• This Splitter/Jack is located inside the motor-end endcap of screen. To access, remove access panel from endcap.
• Data Cables to switches or to additional motors can be plugged into any of the three open jacks.
ILT Data Cable Connection
MOTOR
DATA CABLE
Back of
wall switch.
C
o
D
m
+
o
m
U
5V
w
o
p
DC
n
n
Please Note: This Splitter/Jack is located
inside the junction box of your screen.
Multiple Station Control
Internal Screen Wiring
White (Neutral)
Black
Green/Yellow (Ground)
Dashed wiring
by electrician.
Data Cables
RJ-9
connector
Wall Switch,
RF or IR
Receiver,
or integrated
control system.
To 110-120V Line
(Dry Contacts or Data Cable connection)
Data Cables to
switches or
additional motors
Plug & Play 110-120V Motor
Single Low-Voltage Control
Internal Screen Wiring
White (Neutral)
Black
Green (Ground)
Data
Cable
Wall Switch,
RF or IR
Receiver,
or integrated
110-120V
control system.
Plug
ILT Dry Contacts Connection
OR
C
o
D
m
+
o
m
5V
w
o
DC
n
n
page 7 of 8
(Motor with internal low-voltage controller)
Multiple Low-Voltage Controls
Internal Screen Wiring
White (Neutral)
Black
Green (Ground)
Wall Switches,
RF or IR
Receivers,
110-120V
or integrated
Plug
control systems.
U
p
Please Note: 5V DC must be connected
to set limits using the wall switch.
Data
Cables