Draper Targa Instructions Manual - Page 7

Browse online or download pdf Instructions Manual for Projection Screen Draper Targa. Draper Targa 8 pages. Electrically operated projection screen with motor-in-roller
Also for Draper Targa: Installation & Operating Instructions (4 pages), Installation & Operating Instructions (2 pages), Installation & Operating Instructions (2 pages), Installation & Operating Instructions (2 pages), Installation & Operating Instructions (4 pages), Installation & Operating Instructions (2 pages), Installation & Operating Instructions (3 pages), Installation And Operating Instructions (4 pages), Installation & Operating Instructions (2 pages), Installation & Operating Instructions (2 pages)

Print Page
Draper Targa Instructions Manual
Targa

Section 7 - Wiring Diagrams: Motor with Internal Low-Voltage Controller

110-120V MOTOR AND QUIET MOTOR
110-120V Motor
(Motor with internal low-voltage controller - ILT)
(Internal Low-Voltage Controller for ILT motor)
Single Station Control
Internal Screen Wiring
White (Neutral)
Black
Green/Yellow (Ground)
Data Cable
Dashed wiring
by electrician.
RJ-9
connector
Wall Switch,
RF or IR
Receiver,
or integrated
control system.
To 110-120V Line
Motor with Internal Low-Voltage Controller: Switch-to-Motor
CAUTION: Although both Dry Contact and Data Cable connections are shown, only one connection type per motor should be used.
Please Note:
• This Splitter/Jack is located inside the motor-end endcap of screen. To access, remove access panel from endcap.
• Data Cables to switches or to additional motors can be plugged into any of the three open jacks.
ILT Data Cable Connection
MOTOR
DATA CABLE
Back of
wall switch.
C
o
D
m
+
o
m
U
5V
w
o
p
DC
n
n
Please Note: This Splitter/Jack is located
inside the junction box of your screen.
Multiple Station Control
Internal Screen Wiring
White (Neutral)
Black
Green/Yellow (Ground)
Dashed wiring
by electrician.
Data Cables
RJ-9
connector
Wall Switch,
RF or IR
Receiver,
or integrated
control system.
To 110-120V Line
(Dry Contacts or Data Cable connection)
Data Cables to
switches or
additional motors
Plug & Play 110-120V Motor
Single Low-Voltage Control
Internal Screen Wiring
White (Neutral)
Black
Green (Ground)
Data
Cable
Wall Switch,
RF or IR
Receiver,
or integrated
110-120V
control system.
Plug
ILT Dry Contacts Connection
OR
C
o
D
m
+
o
m
5V
w
o
DC
n
n
page 7 of 8
(Motor with internal low-voltage controller)
Multiple Low-Voltage Controls
Internal Screen Wiring
White (Neutral)
Black
Green (Ground)
Wall Switches,
RF or IR
Receivers,
110-120V
or integrated
Plug
control systems.
U
p
Please Note: 5V DC must be connected
to set limits using the wall switch.
Data
Cables