Draper 58157 Talimatlar Kılavuzu - Sayfa 5

Elektrikli Alet Draper 58157 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper 58157 12 sayfaları. 10 tonne hydraulic bench press

ASSEMBLY

1. Attach both base supports ✖✌ to the main frame ✕✌ using bolts ✗✌, washers ✘✌, spring washers ✙✌

and nuts ✚✌.

2. Stand the frame in the upright position.

3. Support plate ✜✌ and ram plate ✛✌ are held in position on the frame ✕✌ by using bolts ✢✌, washers

✘✌, spring washers ✙✌ and nuts ✚✌. Ensure ribs on both plates are parallel with the front and rear

cross plates of frame ✕✌.

4. The ram ✕✗✌ is fitted through the clearance hole in the support plate ✜✌ and then screwed into

position in the ram plate ✛✌. (Ensure screwed right in).

5. Fit the gauge ✕✜✌ in place on the ram ✕✗✌.

6. Hang the pump (14) on hook located at the top of main frame ✕✌.

7. Attach the hydraulic hose ✕✛✌ to the ram ✕✗✌.

8. Push the two support pins ✕✔✌ through the holes in the main frame ✕✌ and place the table ✕✕✌ in

position.

NOTE: For parts references see parts listing and drawing.

- 5 -