Draper BS355A Talimatlar Kılavuzu - Sayfa 6

Testere Draper BS355A için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper BS355A 20 sayfaları. 360mm bandsaw

Sayfayı Yazdır
Draper BS355A Talimatlar Kılavuzu
1. Lower the blade guard to within
approximately 3mm above the
material being cut.
2. Always keep hands and fingers away
from the saw blade, especially when
coming to the end of a cut.
3. Use a push stick or piece of scrap
wood to do the pushing and guiding
when sawing small pieces which
would otherwise require the fingers
to be close to the saw.
4. Switch the machine off and let the
blade come to a stop before
removing scrap pieces from the
table.
6. Make all adjustments and set ups
with the power off and plug removed
from the power supply, such as tilting
the table, adjusting the saw blade
guards and blade guides.
7. Disconnect the machine before
adjusting the blade tension and the
blade tracking.
8. The cover housing must be in place
and securely fastened before
performing any operation.
9. Securely lock all adjustable parts so
they cannot loosen. This will prevent
distraction from the operation.
10. When sawing curves, make relief
cuts to allow removal of scrap
material. This will help prevent
undue twisting or binding of the saw
blade. The relief cuts are made
before starting the curved saw cut.
11. Hold material firmly and feed into
the blade at a moderate speed.
12. Be sure to use the correct blade size
and type for the application.
13. Do not saw any material that does
not have a flat surface, unless a
suitable support is used.
ADDITIONAL SAFETY RULES FOR
BANDSAWS/DISCS AND STRIP SANDERS
14. Permanently fix your bandsaw to a
bench before performing cutting
operations. (See 'Fastening to a
Workbench', page 9).
15. Use in a well ventilated area and
dust extraction to minimise airborne
dust.
16. Before freeing any jammed material
turn switch off, disconnect from
power supply and wait for all moving
parts to stop.
17. Before starting to cut, watch the saw
while it runs. If it makes an
unfamiliar noise or vibrates
excessively, stop immediately. Turn
the saw off and disconnect from the
power supply. Do not attempt to use
the saw until the problem has been
rectified.
18. Repair or servicing required on this
product should be made only by a
qualified person.When servicing
use only identical replacement
parts.
19. Do not use saw bands which are
damaged or deformed.
20. Replace table insert when worn.
21. When cutting round timber use a
suitable device to prevent twisting of
the workpiece.
22. When bevel cutting with the table
inclined, place the guide on the
lower part of the table .
23. Connect bandsaws to a dust
collecting device when operating.
24. Do not operate the machine when
the door or guard protecting the
band is not closed.
- 5 -