Draper BS355A Talimatlar Kılavuzu - Sayfa 9

Testere Draper BS355A için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper BS355A 20 sayfaları. 360mm bandsaw

Sayfayı Yazdır

Your bandsaw is supplied assembled except

for the work and sanding table. To assemble

the worktable to the bandsaw:

1. Remove the table lock knob

and spring support bush

table support at the rear of the bandsaw

(Fig.3).

2. Remove the hex socket head table

alignment screw and clamp from the

underside of the worktable. Standing at

the rear of the of the bandsaw with the slot

of the table facing the machine, fix the

table so that the blade passes through the

table slot, and the table support rod

goes through the curved slot in the tilt

indicator (Fig.4).

3. Replace the spring support bush

the large flange end facing towards the tilt

indicator.

4. Push the spring

support bush

5. Screw the lock knob

support (Fig.5, 5A).

FASTENING TO WORKBENCH (fixing

bolts not supplied)

Your bandsaw should be bolted to a solidly

built workbench. Mounting holes are

provided in the base of the machine. Large

flat washers should be used between the bolt

heads and the base to fasten more securely

and prevent any damage to the bandsaw.

Tighten snugly but do not overtighten

SPEEDS

Your bandsaw is equipped with pulley steps

for three speeds - adequate for all normal

working requirements. Always use low speed

for cutting nonferrous metals. Medium and

high speeds are used for other materials,

depending on blade type.

ASSEMBLY

, spring

from the

over the spring

onto the table

Fig.3.

with

Fig.4.

Fig.5.

- 8 -

Fig.5A.