Draper CS14A Talimatlar Kılavuzu - Sayfa 12

Testere Draper CS14A için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper CS14A 16 sayfaları. 350mm chop saw
Ayrıca Draper CS14A için: Talimatlar Kılavuzu (12 sayfalar)

Sayfayı Yazdır
Draper CS14A Talimatlar Kılavuzu

TROUBLESHOOTING

WARNING:
MOTOR
Trouble
Motor does not start.
Brush sparking when
released.
GENERAL
Trouble
Angle of cut not accurate.
Powerhead wobbles.
Power head will not rise
fully.
Disc binds, jams
Tool vibrates or shakes.
FOR YOUR OWN SAFETY ALWAYS TURN THE MAIN SWITCH ON THE
MACHINE "OFF" AND REMOVE THE PLUG FROM THE POWER SUPPLY
BEFORE CARRYING OUT ANY MAINTENANCE OR TROUBLESHOOTING.
Probable Cause
1. Fuse.
2. Brushes worn.
3. Other.
1. Normal - automatic brake
working properly.
Probable Cause
1. Misalignment.
1. Loose pivot points.
1. Part failure.
2. Pivot spring not replaced
properly after service.
1. Improper operation.
2. Warped disc.
1. Disc not round.
2. Disc damaged.
3. Disc loose.
4. Other.
Remedy
1. 13 amp time delay fuse or circuit
breaker.
2. See "Maintenance".
Authorized service agent.
Remedy
1. Check for worn pivot.
1. Check/replace worn parts.
1. Authorized service agent.
2. Authorized service agent.
1. See basic saw operation.
2. Replace disc.
1. Replace disc.
2. Replace disc.
3. Tighten wheel flange securing bolt.
4. Authorized service agent.
- 10 -