Draper 20922 Talimatlar Kılavuzu - Sayfa 15

Öğütücü Draper 20922 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper 20922 20 sayfaları. 820w 230v 115mm angle grinder

Sayfayı Yazdır

SETTING THE GRINDER

9.1 FITTING GRINDING DISCS - FIG. 4

Press and hold the spindle lock button

. Loosen the

locking flange

anti-clockwise using the pin

spanner supplied

. The spindle may rotate slightly

before the spindle lock fully engages. Remove the

locking flange only. Clean the flanges and spindle

prior to fitting any accessory. If the rear flange is

removed for cleaning, ensure it locates correctly on

the spindle flats when refitting and does not spin

freely. When fitting the appropriate accessory please

refer to (Fig.3) for specific details on the locking

FIG. 4

flange correct orientation as applicable.

Securely tighten the locking flange clockwise using

the pin spanner while holding down the spindle lock

NOTE: When using wire cup brushes the locking

flange is not required due to the design of the

brushes. When fitted check the accessory is correct

and, importantly fully secure on the spindle.

WARNING: Never press the spindle lock button

while the spindle is in motion.

9.2 ON/OFF SWITCH - FIG. 5

Push switch

forward to start the grinder, the back

of switch lifts and locks in position. To stop the

grinder push the back half of switch

down to

Lock ON

release the lock.

To prevent accidental starting, this machine is fitted

with an electrical safety switch. In a situation of

power failure to the grinder, it will not automatically

Release

re-start when the power is re-connected (despite

switch being in the "ON" position). To reset, simply

switch off

as per Fig.5 and then switch back on.

FIG. 5

OFF

WARNING: Do not set the machine down until the

spindle has completely stopped.

NOTE: During use, keep clothing out of the line of any

sparks formed. Sparks from metal grinding can set fire

to many types of clothing after a short time. The risk

is less if your outer clothing is made of flame

retardant treated cotton.

DUST: A correctly fitted dust mask, suitable for the

activity and in accordance to the relevant standard,

must be worn.

WARNING: An angle grinder is a noisy powertool. We

strongly recommend that ear protection is worn.