Draper 70300 Kullanıcı Kılavuzu - Sayfa 15

Öğütücü Draper 70300 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Draper 70300 20 sayfaları. Angle grinder/cut-off tool

8.2 MOUNTING CUTTING DISCS –

FIGS. 1 – 3

Press and hold the spindle lock button (7).

Loosen the locking flange (6) anti-clockwise using

the hex. key (8) supplied.

The spindle may rotate slightly before the spindle

lock fully engages.

Remove the locking flange only.

Clean the flanges and spindle prior to fitting any

accessory.

Securely tighten the locking flange clockwise using

the hex. key while holding down the spindle lock

button.

Note: When using wire cup brushes the locking

flange is not required due to the design of the

brushes. When fitted check the accessory is

correct and, importantly fully secure on the spindle.

Warning!

Never press the spindle lock button while the

spindle is in motion.

8.3 BATTERY PACK – FIG. 4

Note: This power product is supplied "bare",

without battery pack or charger. Draper 12V

multi-tool interchange battery packs and

chargers are available separately through all

local Draper Tools stockists.

Important: Only Draper 12V designated battery

packs and chargers can be used in conjunction

with this product. Use of any other third party

battery packs/chargers with this product is

considered misuse and will invalidate the

product's warranty.

(6)

FIG. 1

FIG. 2

(8)

FIG. 3

FIG. 4

– 15 –

(7)