Draper 65084 Kullanıcı Kılavuzu - Sayfa 13

Sander Draper 65084 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Draper 65084 16 sayfaları. Dual action air composite sander
Ayrıca Draper 65084 için: Orijinal Talimat Kılavuzu (20 sayfalar)

Sayfayı Yazdır

10. OPERATION AND USE

10.1 OPERATION & AIR REGULATION

– FIG.5

− To start the sander press down trigger (1), and

release again to slow down/stop the pad.

− To alter the amount of air being fed into the

sander, varying the speed, turn lever (4) during

operation. Adjust accordingly.

If the pad is a non punched type use a suitable tool

to pierce the sheet in the appropriate areas. This

will aid with dust removal, reducing the hazard.

10.2 REPLACING THE BACKING PAD

– FIGS.6 – 7

With the air supply disconnected, lift up the edge of

shroud (6) to access the orbital mechanism.

− Insert spanner (8) and locate onto the flats on

the side of the spindle. Hold the spanner while

rotating the pad (5) to remove.

− When assembling do not over tighten the

backing pad.

Note: Always ensure the spanner has been

removed before restarting the sander as the result

will cause damage or injury.

FIG.

(8)

FIG.

Note: Shroud removed to show location

FIG.

– 13 –

(4)

(6)

(5)

(1)