Draper 65084 Kullanıcı Kılavuzu - Sayfa 14

Sander Draper 65084 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Draper 65084 16 sayfaları. Dual action air composite sander
Ayrıca Draper 65084 için: Orijinal Talimat Kılavuzu (20 sayfalar)

Sayfayı Yazdır
Draper 65084 Kullanıcı Kılavuzu

11. MAINTENANCE AND TROUBLESHOOTING

11.1 EVERY-DAY MAINTENANCE CHECKS

Before connection to the air supply:
− Drain the compressor reservoir of condensate.
− Drain the air lines of condensate.
− Drain the combined separator filter, regulator, water trap.
− Fill up the combined separator filter, regulator, lubricant reservoir.
− Check the line pressure is correct for the tool.

11.2 AFTER USE MAINTENANCE CHECKS

− Repeat the above procedures.
− Lubricate the tool with approximately 1.5ml of oil directly down the air inlet.

11.3 TROUBLESHOOTING GUIDE

Problem
Tool will not operate.
Air flows slightly from
exhaust.
Spindle turns freely.
Tool runs slowly.
Air flows freely from exhaust.
Spindle seized.
Tool will not shut off.
We recommend the use of Draper Air Tool Oil:
Possible Cause
Motor or throttle seized with
dirt.
Rotor vane seized.
Motor vane broken.
'O' rings throttle valve
dislodged from seat inlet
valve.
– 14 –
Remedy
Check for dirt in air inlet.
Pour air tool lubricating oil
into air inlet.
Operate trigger in short
bursts.
Disconnect air line supply,
then turn drill chuck by hand.
Reconnect air supply.
If motor fails to turn, return to
service centre.
Pour air tool lubricating oil
into air inlet.
Operate trigger in short
bursts.
Tap motor housing gently with
plastic mallet.
If still not functional, return
tool to service centre.
Return to service centre.
Replace 'O' ring or return to
service centre.