Bosch WLT Series Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 28
Yıkayıcı Bosch WLT Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. Bosch WLT Series 40 sayfaları.
Sayfayı Yazdır
Operating the appliance
en
Start the programme
Press the A button. The indicator lamp
lights up and the program starts.
You will need to press and hold
Note:
the A button to start the programme.
This prevents the programme from
being started if something accidentally
brushes against the button.
The display panel shows the Ready in
time while the program is running or the
program duration and the program
progress symbols once the wash cycle
has started.
Display panel ~ Page 20
Note:
Foam detection
If the Å symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next wash
cycle with the same load.
If you want to lock the program to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
Childlock
(E 3 sec., E 3 δευτ.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock when the
program has started.
To activate/deactivate, press and hold
the Spin speed and Finished in-time
buttons at the same time for approx.
three seconds.The E symbol appears in
the display panel.
E lights up: The childproof lock is
■
active.
28
E flashes: The childproof lock is
■
active and the program selector has
been adjusted.To deactivate the
childproof lock, reset the program
selector to the initial program. The
symbol lights up again.
To avoid the program to
Note:
terminate, do not turn the program
selector beyond the Off position.
The childproof lock remains
Note:
active after the program has ended and
the appliance is switched off. You must
always deactivate the childproof lock if
you want to start a new program.
Soaking
You can soak the washing after
selecting the desired program:
Pour soaking agent/detergent into
1.
compartment II in accordance with
the manufacturer's instructions.
Press the A button. The program
2.
starts.
After approx. 10 minutes, press the
3.
A button to pause the program.
Leave the laundry to soak for as long
4.
as required, then either press the A
button again to continue the
program or change the program.
Notes
Load laundry of the same colour.
■
No additional detergent is required;
■
the soaking solution is used for
washing.
Adding laundry
Following the start of the program, you
can add or remove laundry as required.
Press the A button to do this.
The A button indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
If the following appears in the display
panel: