Drawmer 1970 Operatör El Kitabı - Sayfa 4

Kayıt Ekipmanları Drawmer 1970 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Drawmer 1970 12 sayfaları. Dual fet compressor & pre-amplifier

Sayfayı Yazdır

The 1970 is designed for standard 19" rack mounting and occupies 2U of rack space. Fibre or plastic

washers may be used to prevent the front panel becoming marked by the mounting bolts.

- Care should be taken in the choice of positioning. The unit should not be mounted where other

equipment obstructs the normal air flow. The unit should not be situated near any heat source, such

as a radiator, stove or a high power amplifier that would generate heat.

- The appliance should not be operated near any water or in a location where moisture might be

present.

- Always connect the mains earth to the unit.

If the 1970 is to be continuously moved from one location to another, we suggest using additional support in

the rack at the rear of the unit.

The unit will have been supplied with a power cable suitable

for domestic power outlets in your country. For your own safety

it is important that you use this cable. The unit should always

be connected to the mains supply earth using this cable, and

no other.

If for some reason the unit is to be used at a mains

input operating voltage which is different to that

as supplied, the following procedure must be

carried out.

1: Disconnect the unit from the mains.

2: Remove the two screws holding the voltage

selection cover-plate.

3: Remove the cover plate and slide the switch

fully to its opposite end.

4: Rotate the cover plate one half turn (180

degrees) and refit the two screws.

5: Replace with a correctly rated fuse for the

selected operation voltage in the IEC socket:

230V-T250mA and 115V-T500mA

6: Re-connect to mains power source.

Never disconnect the earth

from the mains supply

INSTALLATION

POWER CONNECTION

DRAWMER 1970 O

PERATOR'S

COVER-PLATE

IEC SOCKET FUSE DRAWER

ANUAL