Dream Catcher ME1310 Manuel

Anten Dream Catcher ME1310 için çevrimiçi göz atın veya pdf Manuel indirin. Dream Catcher ME1310 18 sayfaları. Antenna and propagation (3d) lab 1 introduction to 3d radiation pattern measurement

Sayfayı Yazdır

1. Introduction

ME1310 Antenna and Propagation (3D)

Introduction to 3D Radiation Pattern

This courseware product contains scholarly and technical information and is protected by copyright laws

and international treaties. No part of this publication may be reproduced by any means, be it transmitted,

transcribed, photocopied, stored in a retrieval system, or translated into any language in any form, without

the prior written permission of Acehub Vista Sdn. Bhd.

The use of the courseware product and all other products developed and/or distributed by Acehub Vista

Sdn. Bhd. are subject to the applicable License Agreement.

For further information, see the Courseware Product License Agreement.

Objective

To understand the operating fundamentals of 3D radiation pattern measurements

ii)

To measure and plot antenna radiation patterns

Equipment Required

ME1310 training kit

ii)

Keysight N9912A FieldFox RF analyzer

iii)

Keysight 85033E standard mechanical calibration kit (optional)

iv)

A pair of 2400 MHz dipole antennas

Accessories Required

1 × 5 V power adapter

ii)

1 × Type A-to-Type B USB cable

iii)

2 × SMA(m)-to-SMA(m) RF coaxial cable

iv)

1 × LAN cable

2 x N(m)-to-SMA(f) adapter

vi)

A PC running Microsoft

with setup prerequisites and the RadPat v4 software (Refer to the ME1310 Quick Start Guide for

the installation procedures)

ME1310 Antenna and

Propagation (3D)

Lab 1

Measurement

Rev 1.03

Windows XP/Vista

/7/10 with a minimum of 1 GB RAM, pre-installed

http://dreamcatcher.asia/cw

Lab 1 - 1/18