formlabs Form 2 Manuel - Sayfa 16

3D Yazıcılar formlabs Form 2 için çevrimiçi göz atın veya pdf Manuel indirin. formlabs Form 2 18 sayfaları.
Ayrıca formlabs Form 2 için: Hızlı Başlangıç Kılavuzu (7 sayfalar)

Sayfayı Yazdır

1. Remove the Resin Cartridge
2. Set up
3. Insert the Tank Resin
4. Print
5. Cleaning
6. Cleaning the Tank Resin

Chapter 3

Cleaning

3.1

Cleaning the optical window

Inspect the optical surface.

If you can see some dust :

First, remove the dust with a rubber bulb air blower.

And then R-remove the dust with a dry wipe (moving from the top to the

bottom and then from the left to the right side of the optical window).

If you can see some resin, ﬁngerprints... :

Put a small amount of isopropyl alcohol to an optical paper.

Clean the glass surface with a wet wipe by moving from the top to the bottom

and then from the left to the right side of the optical window.

Clean the glass with a dry wipe to ﬁnish.