Atid ATD100N Kullanıcı Kılavuzu - Sayfa 8

RFID Sistemleri Atid ATD100N için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Atid ATD100N 12 sayfaları.

Operation Guide

When the device is set to Serial mode, the device uses the ATID protocol to communicate with the HOST

device in a command. In order to connect the host device to the device, a demo program provided by

ATID or a program developed using SDK is required.

When the USB cable of the product is connected to the Windows Host device, the product turns

on with a buzzer sound.

2) When booting is normally completed, 'Status LED 2' blinks in green.

3) When connected to Windows Host without problems, the device is assigned a COM port.

COM Port is assigned a different number depending on the PC situation.

•

Check the COM Port number assigned to the 'AT91 USB to Serial Converter' in 'Device

•

Manager → Ports (COM & LPT)' of the control panel.

Depending on the PC situation, driver installation may be required.

•

4) When the program of Windows Host device and ATD100N are connected, 'Status LED 2' stops

blinking and stays on.

5) If data collection starts while the demo program is connected, 'Status LED 1' blinks in red

depending on whether there is data or not.

6) Press and hold the power switch or unplug the USB cable from the host device to turn off the

product.

ATD100N User Guide