Anderson 80G200 Kullanım Kılavuzu - Sayfa 9

Brülör Anderson 80G200 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Anderson 80G200 17 sayfaları.

10.4 Environment

Be sure the burner operating environment matches the original operating

specifications. Check the following items

– Voltage, frequency, and stability of electrical power

– Fuel type and fuel supply pressure

– Adequate fresh, clean, combustion air

– Humidity, altitude, temperature and presence of damaging corrosive gases of the

supply air.

1. Rear cover

Disconnect the pipe to the burner, remove the four bolts of rear cover, then take

down rear cover and rotate it to the position to you want. Then install the four bolts.

Re-connect the piping. Make sure that the O-rings show no signs of damage.

2. Installing the Flame Sensor

Install the flame sensor (UV or flame rod) to the rear cover pipe screw hole or extent

pipe, make electrical connect to flame controller.

3. Installing the Spark Plug

Install the spark plug into the opening in the rear cover, make electrical connect to

flame controller, please to be noted that do not apply any grease to the threads of

the spark plug. You can cause bad grounding of the spark plug if you apply grease to

it. Bad grounding of the spark plug results in a weak spark.

4. Burner Mounting

Fix burner flange with bolts to the wall of chamber, different types of burner

dimension shown in date sheet. Make sure that the wall of the chamber is strong

enough to support the weight of the burner. If necessary, reinforce the area where

you plan to install the burner to support the weight of the burner.

Refractory furnace walls must allow for thermal expansion as recommended by the

refractory supplier – the wall should apply no stress on the burner block or

refractory layer surrounding the burner block.

The combustor or combustion block must not extend beyond the inside of the

furnace wall more than 3mm. Beyond this length it is necessary to add a spacer on

the outside of the furnace to keep the end of the combustor or combustion block

within 3mm of the end of the wall.

If the combustor or burner block is shorter than the furnace wall thickness the block

or combustor should be recessed into the wall. To prevent refractory overheating, a

45° chamfer should be applied

Make sure the ceramic fiber is filled between the burner and the chamber wall if the

gap more than 20mm.

Anderson Thermal Soluions（Suzhou）Co., Ltd

Anderson Thermal Solutions – SSA80 Operation Manual